05-26-2003 12:29 PM - edited 03-02-2019 07:38 AM
I have a PIX 515E running 6.2(2). RME 3.4 has been set up to manage this device. Since adding the device to RME, it has added the "no pager" command to the PIX's configuration. Therefore, when issuing a "wr t" (for example), then the whole configuration scrolls without the "More..." prompt. If the pager command is reconfigured manually to the default, then this stays in place until the next time RME accesses the device to retrieve the configuration. Is this a known issue?
05-26-2003 01:11 PM
Have a look at CSCeb06859
05-27-2003 04:29 AM
Thanks. I found CSCdy13889 which described the problem but was in a "closed" state, which now makes sense if the fault is with the PIX code rather than RME.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: