RME, Configuration Management and needed device attributes
I need to keep copies of the configuration for a router that is on a secure segment of my network. Thus I want to provide as little access to the router as possible through telnet and snmp. In reading all the TAC Authored Notes on RME and transport protocols, it appears that to pull running and startup configurations that I should only need a Read-Only and Read-Write string. However, I cannot pull configurations without using the telnet and enable passwords - and the RW string is not needed. What gives? This is RME 3.4 on Solaris 8 - CD One 5th Edition. Under transport protocols I have the list as TFTP, TELNET, SSH, RCP with the RCP disabled box checked.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.