The RME syslog analyzer is a very useful tool, we have tens of thousands of messages a day.
Many messages are not displayed, they come up in the "Unknown Devices". I suspect this is because RME has discovered the device on one interface eg. serial, but the loopback is used for syslog messages.
I discover in Campus Manager and push the devices across to RME. Sometimes campus Manager does not retrieve the name even though the correct sysname/host name is set.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...