04-19-2002 02:32 AM - edited 03-01-2019 09:22 PM
When adding Catalyst 2950s to RME3.3, they are being caused to reset at the point where inventory/archive collection takes place. This also happens if you manually request an inventory or archive update. Problem only started occurring after upgrade to LMS v2 and software being run on switches is Version 12.0(5.3)WC(1). Any idea anyone?? :-)
Thanks
Nick
04-19-2002 10:42 AM
What specific model of 2950 is this?. The reason I'm asking this is, 2950T model is not currently supported in RME 3.3. Also I see that you're running an old code on this device. You can try first upgrading to the code which cover http://www.cisco.com/warp/public/707/cisco-malformed-snmp-msgs-pub.shtml. Also a niffer trace would be useful to see exactly what's going on between RME and the switch.
04-26-2002 03:44 AM
I had the same problem in Febuary. Back then there was a corresponding Bug CSCdv35805 which I cannot find anymore in the bugtool. Anyway the problem is supposed to be resolved in Firmware v. 13.x
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide