When adding Catalyst 2950s to RME3.3, they are being caused to reset at the point where inventory/archive collection takes place. This also happens if you manually request an inventory or archive update. Problem only started occurring after upgrade to LMS v2 and software being run on switches is Version 12.0(5.3)WC(1). Any idea anyone?? :-)
What specific model of 2950 is this?. The reason I'm asking this is, 2950T model is not currently supported in RME 3.3. Also I see that you're running an old code on this device. You can try first upgrading to the code which cover http://www.cisco.com/warp/public/707/cisco-malformed-snmp-msgs-pub.shtml. Also a niffer trace would be useful to see exactly what's going on between RME and the switch.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...