Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

RME3.4 config management for cat2950G-48

Hy, I can't manage our cat2950G-48 switches.

CM3.2IDU3.0 is installed and devices is supported.

RME inventory supports this device but not supported for config management archive status.

Also not supported when I try to change the device attributes

  • Other Network Infrastructure Subjects
1 ACCEPTED SOLUTION

Accepted Solutions
Blue

Re: RME3.4 config management for cat2950G-48

Config Mgmgt is done be RME, so make sure that you have installed the latest RME IDU first from CCO.

1 REPLY
Blue

Re: RME3.4 config management for cat2950G-48

Config Mgmgt is done be RME, so make sure that you have installed the latest RME IDU first from CCO.

98
Views
0
Helpful
1
Replies
This widget could not be displayed.