Does anyone have any references (books, web pages, etc) that help to explain how to program RMON probe capabilities into a device? I just can't seem to find anything. Any help would be greatly appreciated!
Thanks for the response. Actually, I'm consulting with a company that is making transportation equipment for the tv cable industry. Some of their clients are asking for some RMON support in their equipment. No there knows how to do it. I've gotten them some of the basics, but would like to find a whitepaper or tutorial or something to help explain how to write the code for the RMON probe.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...