rotary reverse-telnet sessions across more than one router.
I'm trying to create a config which will allow me to telnet to an address from my LAN and then that address will map to one of many async lines depending on what is available. I.e. if I telnet to 10.10.10.1 I could be sent to either line 1 on router 1 or say line 4 on router 2.
What I'm trying to resolve is management of Marconi communications devices via 2511s. Currently our techs have to reverse-telnet to a connection on the device, and if it is in use, reverse-telnet to another port. I want to automate this so that the techs will automaticlly be put through to an available port.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...