10-27-2003 10:29 PM - edited 03-02-2019 11:17 AM
I was using route-map on SUP720, I wish to have route-map applied on those HTTP traffic. Though I found the route-map is worked, I can't see any matches on the route-map command. However, if I was using the route-map to match the icmp traffic, then, I can see the matches on the route-map.
I wonder if there is any other command to see the match on route-map, other than using "sh route-map <route-map_name>
Below shows the scenario:
6509#sh route-map http-redirect
route-map http-redirect, permit, sequence 10
Match clauses:
ip address (access-lists): 110
Set clauses:
ip next-hop 202.11.238.250 202.11.238.251
Policy routing matches: 0 packets, 0 bytes
6509#sh ip access-lists 110
Extended IP access list 110
10 permit tcp 202.11.146.0 0.0.0.255 any eq www
10-28-2003 01:22 AM
Are you running Hybrid ? if so you should be able to use the command:
show mls entry pbr
10-28-2003 06:07 PM
No, it is on integrated IOS.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: