Route maps on 3550 switch

[Shobith K]

I have to perform policy based routing on 3550 L3 switch with 5 vlans.

here is the scenario.

i have these vlans - 192.18.1.0, 192.18.2.0, 192.18.3.0 etc...

i have a remote location 203.x.x.x which located in US and is connected through IPLC link through a router.

There is one more firewall with 192.168.9.2 as inside interface configured.

there is a site to site vpn through internet configured to this remote site on this firewall.

Both these firewall and the router is connected to the switch..

I want 192.168.3.0 network to go through this gateway ie 192.18.9.2 while accessing remote 203.x.x.x network.

can any one please help me in doing this...

[skarundi]

here is a policy routing example that might help you. Please review the document.

Doc ID:47900

URL: http://www.cisco.com/en/US/tech/tk364/tk871/technologies_configuration_example09186a00802135d3.shtml

[Shobith K]

i have got the desired output when i tried with the configuration.

But int eha access list menitoned in the link only source address is mentioned. iwant the traffic to be filtered based on the source and the destination.

can it be done using route maps...

[tbaranski]

Yes -- just reference an extended ACL that matches both the source and destination addresses.

[Shobith K]

i have tried giving an extended acl with source and the destination address, but is is not working.