12-12-2005 06:19 AM - edited 03-03-2019 01:06 AM
Can someone please tell me what is the correct way to add the 'delay ' factor into route resdistribution. eg. If the delay is 100 or 5 or 8 ms what is the correct way to add it in.
e.g.Bandwidth = 64kbps
Delay = 100 / 5 / 8MS (any of these)
Reliability = 255
Load = 1
MTU = 1500
#redistribute isis level-1 metric 64 100 255 1 1500
Is it just put in as follows in mseconds 100 or 5 or 8
Thanks for your help
12-13-2005 04:14 AM
Surely someone has a clue ??
12-13-2005 08:03 AM
Generally, we don't try and figure out what to set the dealy at to "mimic" the redistributed protocol's delay. Instead, we just pick a delay that seems "right," and use that. Note there's no way to actually change the delay base don the inbound metric at this point, though we've talked about doing that in the past.
:-)
Russ.W
12-16-2005 07:05 AM
tks for the reply
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: