Router with hostname pir1 is the route reflector here.
But you need to correct the bgp config on the pir1 router. You should change this statement "neighbor 172.30.0.1 route-reflector-client " to "neighbor 172.30.0.2 route-reflector-client ", so that the route reflector considers p1r3 as a route reflector client.
Now pir1 will be the reflector and p1r3 and p1r2 will be the clients.
You have a failrly simple config here. The first thing that jumps out at me is the neighbor statement on your route-reflector doesn't match up. It should be
neighbor 172.30.0.2 remote-as 100
neighbor 172.30.0.2 route-reflector-client
I think that will get you up an running. The other thing, you might want to take your advertised networks such as 10.0.0.0/8 and place a route to null 0. From the router that it advertising the network it is always good practice because if the route is not in the routing table, BGP will not advertise it. Turning off syncronization may help also.
I write wrong.If I write neighbor 172.30.0.1 remote-as 100 and neighbor 172.30.0.1 route-reflector-client ,the router say wrong.I know that igp route have know to arrive it10.0.0.0/8,so i think It needn't to write no synchronization.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.