Okay.... I have a 2610 configured as a router on a stick, w/ a dot1Q trunk to a 3508. I have 4 vlans configured. My default route on my 2610 is set for the inside interface PIX 515, which is connected to my ISP's router. I just got in 2 more T's from another ISP, which is connected to a Cabletron Switch that the ISP owns. I need to be able to route certain Vlans out through one ISP and the other Vlans out the other (No load balance). I also need to know, what, if any equipment I will need to do this. Rememeber, I only have the Pix 515 w/ an inside and an outisde interface that are already in use and a 2610 for internal routing. I am trying to get the right equipment and do the right config for routing Vlans to 2 diferent ISP's. Thanks for you help!
Equipment looks like this:
router (ISP owns) 2 new T's (other ISP)
I I
I I
Pix 515 2610 (default gateway & Vlan router)
I I
I_ _ _I
Cat 3548 (uplinked to 3508)
I
I
Cat 3508 ( 8 GB ports segmented into 4 Vlans)