Also on another 2611 router i make changes to the start up config, and they are saved. but when i look at the running config, there is this one line in my access list that won't get removed. its not in my start up config only in my running config. i tried running, copy start run, but the line doesn't go away. any ideas? i tried a reload and that didn't help.
The boot problem sounds like the config register is se to "ignore nvram config at startup". sh ver to see what the config register is set at. I'd have to look up which bit ignores the config but it should be x2102. If not go to config mode and set it with config-register x2102. Save and reload. If you saved teh config while in this state your original config will be gone. If not it should be there.
If your stuck in rommon then type in configreg (something like that, the ? will show you) It starts an interactive process that asks what settings you want and changes them bit by bit. Not having the 0 int front of the x2102 might have messed it up; sorry. My routers wont take it without the leading 0.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.