I wanna know if this is going to work, sorry i'm a novice
i have a cisco router 2621 with cisco ios 12.2 (4T), 32Mb flash and 64mb ram, wic with two serial one connected to a frame relay one free, we use to access to the internet. by this serial we have a pool of 16 fixed ip adresss.
i want to do this: install a ADSL wic card, but i want the two cards work for the internet conection, ADSL use DHCP to get the ip adress. i want to know if we going to have some problem with the routes, because one serial interface (frame relay) uses igrp, and how the router will chose to send the traffic.
You can have multiple connections to the Internet and choosing which interface to use depends on the routes that you have in the routing table pointing to different interfaces. Though you are running IGRP on one of the serial interfaces, you could have static routes or use a routing protocol like BGP to connect to internet and packets will be forwarded to Internet using those interfaces based on the routing table entries.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...