Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Router Banner

Hi

When I issue a banner motd command and type a message , only the first 3 letters of my message appear how do I get the entire message to be displayed

Thanks

2 REPLIES

Re: Router Banner

Are you sure you are using the delimiting character correct way?

See http://www.cisco.com/univercd/cc/td/doc/product/software/ios120/12cgcr/fun_r/frprt1/frconban.htm#1017572

for details.

Regards,

Milan

New Member

Re: Router Banner

your Delimiting character is must be the 4th char in your mssg and therefore only first three char are displayed in routes banner. pl use some special char as Delimiting character such as $ or # those are not included in msg. the Delimiting character is nothing but char which indicats start and end of your msg.

ashman

89
Views
4
Helpful
2
Replies
CreatePlease login to create content