Router(boot)# in a 6500

[pgasol]

Hi, I have a 6506, in the first slot there is a WS-X6K-SUP1A-2GE with a MSFC

When i put session 15 the router boots like this:Router(boot)#

I want that it boots normally, how must I do?

Router(boot)#sh bootflash:

-#- ED --type-- --crc--- -seek-- nlen -length- -----date/time------ name

1 .. image E58D8560 1C8500 24 1606784 Mar 25 2000 21:30:40 c6msfc-boot-mz.120-7.XE1

2 .. image 38FCD6C4 8379A0 22 6747168 Mar 25 2000 21:31:10 c6msfc-js-mz.120-7.XE1

7636576 bytes available (8354208 bytes used)

Router(boot)#sh bootvar

BOOT variable = c6msfc-js-mz.120-7.XE1,1;

CONFIG_FILE variable does not exist

BOOTLDR variable = bootflash:c6msfc-boot-mz.120-7.XE1

Configuration register is 0x102

Router(boot)#sh start

Using 328 out of 126968 bytes

!

version 12.0

!

hostname Router

!

boot system flash c6msfc-js-mz.120-7.XE1

boot bootldr bootflash:c6msfc-boot-mz.120-7.XE1

!

ip subnet-zero

Many thanks in advance

[lgijssel]

With boot system, you also need to specify the flash partion.

My supervisor boot from its own flash-partition, called sup-bootflash.

Please try the following:

Move or copy the image to sup-bootflash

Alter your boot-parameters accordingly, i.e.:

boot system flash sup-bootflash:c6msfc-js-mz.120-7.XE1

[Prashanth Krishnappa]

The boot command you have is incorrect. The correct boot command would be

config terminal

boot system flash bootflash:c6msfc-js-mz.120-7.XE1

config-register 0x2102

end

write mem

At this time, if you reload, you should be good to go

[lgijssel]

In contradiction with the docs it appears that the correct value for the config reg is 0x102. There have been other postings regarding this issue and the conclusion was that: config-register 0x2102 is not correct.

config-register 0x102 is the correct setting for a 6509 supervisor.

regards,

Leo