Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Router config 2620, NAT issue

I have setup static NAT on the router so that users on Internet can reach my webserver(Intranet) on Local LAN. Users access this webserver (Intranet) by clicking a link on our company website. This is working fine and the address 208.251.72.60 gets translated to 192.168.0.206 as long as users are sitting outside on the WAN.

The problem is when users sitting inside on the local LAN click the link on the webpage the address 208.251.72.60 does not take them to the Local webserver 192.168.0.206.

Is there a way to acheive this using the router. Thanks

1 REPLY
Cisco Employee

Re: Router config 2620, NAT issue

I think you have PAT configured like this.

ip nat inside source static tcp 192.168.0.206 80 208.251.72.60 80

only,,This will do following

translates the source of IP packets that are traveling inside to outside

translates the destination of the IP packets that are traveling outside to inside

You are loking to achive the reverse too so you need to have following too.

ip nat outside source static tcp 208.251.72.60 80 192.168.0.206 80

Above will do following

translates the source of the IP packets that are traveling outside to inside

translates the destination of the IP packets that are traveling inside to outside

This should work exactly the way you are looking for.

for more information pl. visit..

http://www.cisco.com/warp/public/556/2.html

256
Views
0
Helpful
1
Replies
CreatePlease login to create content