I have a very strange phenomenon, where after the last change about 1 month ago, the NAT lines of the config to a 2600 router are reversed, i.e. the first line has become the last line, etc. Has anybody seen anything like that?
Not exactly understanding the scenario, but did you add any command, (related to nat) during that time, If you have an idea how it looked one month back, then please post both configuration outputs(the one before, and one that is now)
Ensure you don't have your "ip nat inside" and "ip nat outside" statements reversed on your interfaces. "ip nat inside" should be on the interface connected to your private network, and "ip nat outside" should be on the interface connected to your public network (WAN or outside).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...