Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Router config-register 0xC502

Hi All,

I have Cisco 2811 Router and few days ago my router doesn't work correctly. I checked config and found config-register waas changed (0xC502).

HUV_Murun#sh version

Cisco IOS Software, 2800 Software (C2800NM-IPBASE-M), Version 12.4(9)T7, RELEASE SOFTWARE (fc3)

Technical Support: http://www.cisco.com/techsupport

Copyright (c) 1986-2008 by Cisco Systems, Inc.

Compiled Thu 10-Jan-08 16:35 by prod_rel_team

ROM: System Bootstrap, Version 12.4(13r)T, RELEASE SOFTWARE (fc1)

HUV_Murun uptime is 23 hours, 36 minutes

System returned to ROM by power-on

System image file is "flash:c2800nm-ipbase-mz.124-9.T7.bin"

Cisco 2811 (revision 53.50) with 251904K/10240K bytes of memory.

Processor board ID FHK1228F2RY

2 FastEthernet interfaces

1 Serial interface

6 Channelized E1/PRI ports

DRAM configuration is 64 bits wide with parity enabled.

239K bytes of non-volatile configuration memory.

62720K bytes of ATA CompactFlash (Read/Write)

Configuration register is 0xC502

Anybody know what is the meaning of this config-register (0xC502) and how can be changed config ?

BR,

Tuvshuu

3 REPLIES
Hall of Fame Super Gold

Re: Router config-register 0xC502

how can be changed config

Go to configuration mode and enter the command "config-register 0x2102".

Use of the Configuration Register on All Cisco Routers

http://www.cisco.com/en/US/products/hw/routers/ps133/products_tech_note09186a008022493f.shtml

Please don't forget to rate useful posts.  Thanks.

Re: Router config-register 0xC502

Tuvshuu:

Although I have not used it in a very long time, there is a free software utility "Config Reg Calculator" offered by Boson, which "allows you to determine what a router will do given the configuration  register value".

It is available at:

http://www.boson.com/FreeUtilities.html

Perhaps it might be of interest to you.

Best Regards,

Mike

New Member

Re: Router config-register 0xC502

Tuvshuu::

config-register (0xC502)  means

C- 15th and 14th bit set

14th-IP broadcasts do not have network numbers

15th-Enable diagnostic messages and ignore NVRAM contents    

5- 8th & 10th bit set

8th-Break disabled

10th-IP broadcast with all zeros

0-

2-Boot field

Thanks and regards.

HNZ

Thanks HNZ
798
Views
0
Helpful
3
Replies