Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Router Configuration for Wake On Lan

We are using WOL successfully on individual segments of our network but cannot wake a PC if it is on a segment other than the management PC.

Our network consists of 2 - 6509's at the core and 40 fiber connected locations running 3500 gear. Each location is run as a VLAN and all routing is handled by the MSM's in the 6509's.

How do the MSM's need to be configured to pass the WOL requests?

1 REPLY
Anonymous
N/A

Re: Router Configuration for Wake On Lan

WoL is a UDP packet dest. port 9. So try configuring 'ip forward-protocol udp 9' at the global config and 'ip helper-address [WoL server's ip]' on the interfaces clients are connected on your 6509s

432
Views
0
Helpful
1
Replies
CreatePlease login to create content