I'm trying to configure a Cisco 3640 with remote-shell commands. Accessing the router is no problem, I've configured the required commands:
ip rcmd rsh-enable
ip rcmd remote-user user 10.10.250.1 user enable
I'm using the rsh command from a Windows 2000 client. Normal enable-mode commands can be executed without problems. But how do I enter configuration-mode commands? After sending a 'configure terminal' first, the router isn't changing to the config-mode permanantly.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.