we have about numerous 2610XM with NM-8AM modules. Linux servers dial into these 2610XM's as well as Dial-Out from the routers into the Linux servers.
One of the sites is having a problem where all clients dialing into a particular 2610XM get connection speeds between 21.6 and 28.8kbps. When however, the router dials to any of the locally configured clients, the speed achieved is usally only 9600bps or less. The modem configs on all routers and Linux boxes are identical.
My questions is : are there any ways in the 2610XM to check the line quality as welll as any guide to trouble shoot low connection speeds?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...