Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Router hangs at initial configuration dialog

Hello,

my 2620 hangs at the initial setup:

-------------------------

Cisco Internetwork Operating System Software

IOS (tm) C2600 Software (C2600-I-M), Version 12.0(7)XK1, EARLY DEPLOYMENT RELEAS

E SOFTWARE (fc1)

TAC:Home:SW:IOS:Specials for info

Copyright (c) 1986-2000 by cisco Systems, Inc.

Compiled Wed 15-Mar-00 04:28 by phanguye

Image text-base: 0x80008088, data-base: 0x8080DBA0

cisco 2620 (MPC860) processor (revision 0x600) with 45056K/4096K bytes of memory

.

Processor board ID JAD05320R17 (3691429275)

M860 processor: part number 0, mask 49

Bridging software.

X.25 software, Version 3.0.0.

1 FastEthernet/IEEE 802.3 interface(s)

32K bytes of non-volatile configuration memory.

8192K bytes of processor board System flash (Read/Write)

--- System Configuration Dialog ---

Would you like to enter the initial configuration dialog? [yes/no]:yes

----------------------

I can't get into rom Mode either.

Any ideas?

Regards

Eicke

2 REPLIES
VIP Purple

Re: Router hangs at initial configuration dialog

Hello,

when you enter NO at the system configuration dialog initial configuration question, do you get a router prompt ? If so, change the configuration register to 0x2102 and reboot the router:

Router#conf t

Router(config)#config-register 0x2102

Router(config)#end

Router#wr

Router#reload

HTH,

GP

New Member

Re: Router hangs at initial configuration dialog

Hello,

thanks for your idea.

I finally changed to another "original" cable. And it worked.

Regards

Eicke

714
Views
0
Helpful
2
Replies