Router hangs...

[rajankumaresan]

we hv faced the similar problem for abt three times

some times,

i cud not even ping my router interface..when i reset (Power) an dafter some time started working..is there any prob with interface..

2621 with wic 1 T is there...2mb is incoming b/w..i hv configured 128K to fa0/1 thru rate-limit cmd...is that correct?.....and b/w assigned to fa0/0 is 1800kb, serial = 2mb

what cud be the problem...

dividing b/e for the above config, what cmd shd i use...traffic-shafe? or rate limit ?or custom queing?

[ciscomoderator]

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.