Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Router id changes but still getting message of another duplicate router id

Hi,

i configured ospf and it automatically took the highest ip as its router id,now i wanted to change the router id to a loopback interface ,i disabled ospf and defined loopback interface and set the router id in ospf to it,it does change the router id if i do show ip ospf to the loopback interface ip,but i get the message for a duplicate router id giving the value of the previous one.

ANy ideas >>>???

1 REPLY
New Member

Re: Router id changes but still getting message of another dupli

When I added loopbacks, I actually had to reload the router to get it to take the loopback IP as the router ID. SH IP OSPF NEI on a nearby router should tell you how this router is known to the rest of the world.

I have to admit, I went right to reloading the router. I figured that trying to figure it out instead of just fixing it was more an acedemic exercise. When a warm supper is at home, I generally shy away from acedemics!

140
Views
0
Helpful
1
Replies