I currently have a router that is an LP state. I am not showing the serial interface being in loopback (loopback not set) when I do a show interface cmd. Is there something I need to do to clear it out of an LP state?
If your interface is not showing as being looped but your LED is showing as amber, there is a good chance that your provider may have put a loop on the line to test the circuit and they did not take it off.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...