Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Router Installation

Hi alll,

Can anybody tell me , how to install a router from basic ...

mean taking router from BOX pack no IOS no flash nothing..

pls tell me the procedure..caz i never done or seen it ..but as a n/w engineer i should know this..

pls tell me sequentially..

thanx,

Mangesh

2 REPLIES
Silver

Re: Router Installation

Mangesh,

Type "setup" and answer questions asked. Routers are shipped with IOS and flash. This is a very very broad question due to everyone's setup / environment is going to be unique and have unique requirements, as far as the setup goes. Please give much more detailed information if you would like more detail to your question. Hope this helps you.

Regards,

Don

New Member

Re: Router Installation

Hello there,

as it has been said, you asked a very broad question and this is usually covered in large manuals, instead of a mere message on a board.

Let's say, first of all, that Cisco is very good in documenting things and each hardware product (at least those I have been working with) has an hardware installation guide, which I suggest, you should read.

Where to find it?

type http://www.cisco.com/univercd the product documentation page will show up. Let's say you have a 2600 to install so you choose the router drop down box and the the modular router item (sorry but you need to know what kind of equipment you are working with). This asction will bring you to the following URL:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/index.htm

Here you select the router series you want (we said 2600) and on the resulting page you select the Hardware installation documents, on the next page you select the hardware installation guide and then the first link is the whole guide in .pdf format. The link you should end up with is:

http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis2600/hw_inst/2600hig/2600hig.pdf

I suggest you read this through since it explains alot wich is applicable to lots of other routers. Since this is a modular config router it will explain network module and wan interface card installation too. This is a 120 pages document which I cannot sintetize in a post.

I hope this is what you are looking for and there should be one for you specific hardware type.

Fabio

187
Views
0
Helpful
2
Replies
CreatePlease login to create content