Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Router not clearing NAT translation

2 x Cisco 2600 router, Version 12.3(13) - HSRP configured

Server in DMZ with a static NAT to a public ip.

Periodically the router will stop NATing outbound traffic from this server. Clearing the NAT translations doesn't work. When the router is failed over to the other router in the HRSP config, the NATing works. When the original router that was causing the problem was reloaded and was made the active HRSP router, the NATing also worked.

It appears the server is causing the problem possibly due to a faulty nic or corrupt tcp/ip stack, but ultimately the router is the device hanging onto the bad connection/NAT transaltions.

Anyone have any ideas what would cause the router to do this?

2 REPLIES
New Member

Re: Router not clearing NAT translation

Hi

During NAT fail, are there any messages in the router syslog?

New Member

Re: Router not clearing NAT translation

Hi

No, there are no messages at all, and the ip nat translations clearly show no translation for this nat'ed address. It almost seems like the server (dmz address) has caused a 'bad' connection but the router couldn't clear it even after the server is rebooted

338
Views
0
Helpful
2
Replies