I am working on a customer site. The customer has a Core router (L3 blade in a switch. That router routes to all subinterfaces (VLAN's).
There is a default route Statically configured on the Core to one of 2 egress PIX's.
I am trying to configure the PIX's to multicast their default route in to Core so that the Core router will update its routing table.
I know I have the PIX's configured correctly because I have captured the traffic in sniffer using RIP filter.
What I see no evidence of is the Core router ever receiving any updates. I have enalbed debug ip rip on the Core, but it will not output anything. When I check the routing table on the core, it does not have any rip updates..
What do I need to do to ensure that the Core Router is getting the RIP updates???
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...