Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Router Uptime and Cisco Works

Which report do I run in Cisco Works to just show me the device name, IP and uptime? I have about 140 routers where I need the information. I don't need any other information from the devices.

Thank You

2 REPLIES
New Member

Re: Router Uptime and Cisco Works

Oh.. CW version 4.0

thanks!

New Member

Re: Router Uptime and Cisco Works

Yes, CW no longer has this in the reports output. I use Netshow commands and immediate execution. Make sure to enable the remote console. You can only do reports in groups of 10 so you have to run 14 reports. You can also define and then schedule these.

Hope this helps.

84
Views
0
Helpful
2
Replies