Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our beta test area to get started.

New Member

Router went disable when inserting GEIP+

Hi,

Yesterday we made a change on a 7500 router. we inserted a GEIP+ module in one free slot and inmediatly the router stop working and all slot went to the disable state. We reload the router and everything came back to normal. Unfortunely we don´t have the log files at that moment, do you have an idea what may happen?

Regards,

Aisha Sanes

  • Other Network Infrastructure Subjects
1 REPLY
Bronze

Re: Router went disable when inserting GEIP+

Without the log files, it is difficult to determine what caused the failure. If the problem happens again, be sure to capture the log files and open a case with Cisco for further analysis.

78
Views
0
Helpful
1
Replies