I want confirmation that my thought process is correct.
I currently have several Class C networks (192.9.X.X) running at various regional offices and want to change over to a 10.x.x.x network.
Can I change one regional office at a time to 10.X.X.X. while leaving the other office at 192.9.X.X. as long as I add the 10.X.X.X to my EIGRP config and still have fully connectivity between them. All office are running Cisco 3600 series routers.
I think if you are using EIGRP then there should not be any issues regarding calss C and A, the only thing you have to take care is that Your Router Local Ethernet should be properly address and EIGRP config should contain network 10.0.0.0.
another way you can test this is to add this network in your routing topology and place a workstation on this network, you have to assign a sec address to your ethernet for the gateway and then you can test all the services with that Workstation.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...