We have 7200 routers where we terminate the dialup users. Each router has its own address pool. However, some dialup users ask for static IP addresses. I don't know to which terminal router they will connect.
I am using ISIS between these routers and the rest of our network.
Since I am excluding the static IPs subnet from the ISIS announcement, I had to announce them as "connected" .
This will disturb the routing table with frequent triggered updates b/c of the connection/disconnection of the dialup.
Am I doing the right thing or is there a better solution.
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...