I am running a EIGRP network with the 2 central routers running HSRP across their lan interfaces. The primary router redistributes static routes defined on this router into EIGRP. However if this router fails and the backup router takes over within HSRP, how do I ensure that the EIGRP routing protocol is aware of these static routes? Would I have to configure these routes on the second router and redistribute back into EIGRP with a higher weighting?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...