I have a 4006 with a Sup III. I have 3 VLANs configured on this switch and have a Cisco 4700 connected to one of the Fast Ethernet ports of the switch, this port is a member of one of the 3 VANs. I have enabled eigrp 2 on the 4006 and was just expecting it to receive updates from the 4700 router... But this is not the case so I'm obviously missing something (probably something very obvious). What do I need to do to get the routing updates from the 4700 router into the 4006 switch? At the moment the 4006 knows about all connected VLANs but thats it.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...