03-20-2006 09:56 PM - edited 03-03-2019 02:23 AM
I am trying to make a 3550 Port a routing port, but when i make a routing port through "no switchport"
display message VLAN1 is already enabled for management so ip cannot be assigned to routing port.
thank you.
03-20-2006 10:08 PM
Hi Mansoor,
Can you please post the output of that port.
sh run int
Regards,
Ankur
03-20-2006 10:21 PM
Can you make sure ip routing is enabled? Can you also do a show ip route and post it here at least if you do not want to post the show run and show ver?
03-21-2006 03:33 AM
Hi Mansoor ,
AFAIK on 3550 switch you can only configure one port with an IP address .If you have already configured VLAN with one IP address you cant configure other IP address. To confirm what you can do this if you remove the IP address of VLAN 1 and then add IP address to that Routing Port or to someother VLAN.
Hope that helps..
regards
Ab
03-21-2006 03:55 AM
Ab
[q]AFAIK on 3550 switch you can only configure one port with an IP address [/q]
that's not true, you can make 24/48 port router from a Cat3550 / 3560
this applies to 2950 - only 1 ip interface
03-21-2006 05:36 AM
Hi Salomon,
I tried configuring 2 IPs on WS-C3548-XL-EN , but it was letting me configure.i dont know may be u r right.
regards
Ab
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide