Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Routing Port

I am trying to make a 3550 Port a routing port, but when i make a routing port through "no switchport"

display message VLAN1 is already enabled for management so ip cannot be assigned to routing port.

thank you.

5 REPLIES

Re: Routing Port

Hi Mansoor,

Can you please post the output of that port.

sh run int

Regards,

Ankur

Re: Routing Port

Can you make sure ip routing is enabled? Can you also do a show ip route and post it here at least if you do not want to post the show run and show ver?

New Member

Re: Routing Port

Hi Mansoor ,

AFAIK on 3550 switch you can only configure one port with an IP address .If you have already configured VLAN with one IP address you cant configure other IP address. To confirm what you can do this if you remove the IP address of VLAN 1 and then add IP address to that Routing Port or to someother VLAN.

Hope that helps..

regards

Ab

New Member

Re: Routing Port

Ab

[q]AFAIK on 3550 switch you can only configure one port with an IP address [/q]

that's not true, you can make 24/48 port router from a Cat3550 / 3560

this applies to 2950 - only 1 ip interface

New Member

Re: Routing Port

Hi Salomon,

I tried configuring 2 IPs on WS-C3548-XL-EN , but it was letting me configure.i dont know may be u r right.

regards

Ab

104
Views
0
Helpful
5
Replies
CreatePlease to create content