Routing preferences between static and dynamic routing
If I have 2 routes pointing to the same subnet destination, one static & one dynamic, then the static (lower AD value) route will be the one that gets installed in the routing table, right ? But, if say that the the next-hop interface to which the static route pointing to is down, will the dynamic route gets installed in the routing table ?
Re: Routing preferences between static and dynamic routing
Thank you very much for your prompt response. However, since the primary route is a static route and the secondary route is a dynamically learned route, and the primary will always remain in the routing table (as I think that it cannot detect the next-hop-ip interface is down), in this case, the secondary dynamically learned route will never be used by the routing table.
I will agree with you, unless the static route is able to detect that its "peer" is down. But, I don't think static route can do that.
Under other circumstances, if both primary and secondary route are dynamically learned routes, that what you said before will work.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.