Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Routing problems through Async interface

Hi,

I'm successfully connecting two routers through a DDR configuration, however I need to pass dynamicaly two routes for networks that are directly connected to the Router that is starting the DDR connection. Although I configure in the Async interface: async dynamic routing, it doesn't work. Has anybody know what can I do.

Regards,

Berlitz

2 REPLIES
Cisco Employee

Re: Routing problems through Async interface

Try "async default routing" under the async interface.

Harold Ritter
Sr. Technical Leader
CCIE 4168 (R&S, SP)
harold@cisco.com
México móvil: +52 1 55 8312 4915
Cisco México 
Paseo de la Reforma 222 Piso 19
Cuauhtémoc, Juárez
Ciudad de México, 06600
México
New Member

Re: Routing problems through Async interface

According to some Cisco Doc I found, you should use "Async dynamic routing" command under the As interface. Unfortunately this does not work for multicast/broadcast based routing ptotocols. You can run BGP using this command, but not RIP or OSPF. The proper command as stated in the previous post is "async default routing." This will work for sure.

94
Views
0
Helpful
2
Replies