Well, honestly depending on the routing protocol you are going to use. EIGRP and OSPF for example depend on which interface will form neighor relation ship and depending on what network is on the interface it will be advertised. However, BGP does not depend on the interface and you use the network command to advertise the subnet you want.
Therefore, when you issue the network command under the EIGRP and OSPF it means you are saying that these interfaces can send and receive hello packets and form adjacency or neighbor relation ships. However, the advertised subnet will be that of the interface. For example, if you issue the command network 10.20.30.1 0.0.0.0 this means only this interface will form neighbor relationship however the advertised subnet would be 10.20.30.0/24 in case this is the interface subnet.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...