I have a switch connected to a RPS300. When I fail the AC input to the switch, the RPS supplies power to the switch. However, when I restore the AC power, the RPS remains blinking Green and when I press the standby/active button, the switch reloads.
Is this normal?
If it is, it would suggest that a RPS300 continues to supply power to the switch on AC failure, until the switch is reloaded with the AC power restored.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...