Try a different slot, if you still have the same issues and console does not respond, I would suspect bad hardware. RSM is supported in CAT5000 chassis. Here is an example form my lab switch(which has a Sup3)
Elgswc1 (enable) sh ver
WS-C5000 Software, Version McpSW: 4.5(7) NmpSW: 4.5(7)
Copyright (c) 1995-2000 by Cisco Systems
NMP S/W compiled on May 19 2000, 13:49:36
MCP S/W compiled on May 19 2000, 13:47:24
System Bootstrap Version: 3.1.2
Hardware Version: 1.8 Model: WS-C5000 Serial #: 009603180
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...