Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

RSPAN and 6509,2950 and 4006

Hello, I have the following scenario

cat6509-----cat4006-----cat2950-----cat2950

I have setup a vlan for span on the 6509, added the monitor session commands on the cat2950's but I can only see broadcast traffic on the monitored port( I see the correct monitored vlan but not specific traffic eg icmp etc). I think there is a problem with the supervisor on the cat4006 which is a "WS-X4013". Here are my configs

cat2950

monitor session 2 source int f0/42

monitor session 2 destination remote vlan 700 reflector-port Fa0/4

cat2950 no, 2

monitor session 2 destination interface Fa0/4

monitor session 2 source remote vlan 700

I have trunked the vlan 700 all the way between the switches

Any help would be appreciated. I have tried moving the root of the spanning tree for vlan 700 to be one of the 2950's but there is no command to do a rspan on the vlan of 700, only on the 6509 or the cat4006 is there a set "vlan 700 rspan" command.

thanks again

1 REPLY
Silver

Re: RSPAN and 6509,2950 and 4006

Check if the following document is of help to you.

http://www.cisco.com/warp/public/473/41.html

365
Views
0
Helpful
1
Replies