07-06-2006 10:19 AM - edited 03-03-2019 03:56 AM
How can I create RSPAN between two 3548 switches, which is in different VTP domain? Both switches have 12.0(5)WC9a on them and support "port monitor..." interface command.
Is it possible to create RSPAN between two different type of switches? If so how can I do that? What are the requirements? Thank you.
Regards,
Santi
07-06-2006 04:28 PM
RSPAN is not supported in any of the XL switches, 2900XL/3500XL. You need at least a 2950:
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2950/12122ea7/scg/swspan.htm#wp1036704
Please note that 2950 is not the same as 2900XL or 3500XL.
Please rate all posts.
07-07-2006 03:25 AM
Hi Roberto:
Does "Reflector Port" have to be empty, nothing connects to the port?
07-07-2006 03:31 AM
Yes, Reflector port has to be empty. There should not be anything connected to it.
HTH, Please rate if it does.
-amit singh
07-07-2006 03:53 AM
Hi Amit,
Do I have to assign reflector port to a special VLAN ID (Remote Span VLAN), and allow this VLAN traffic through the trunk?
07-07-2006 05:34 AM
Hi Santi,
No You dont have to put the reflector port in any vlan. Just assign any port as a reflector port and it will not longer be a part of any vlan.
http://www.cisco.com/univercd/cc/td/doc/product/lan/c3550/12225see/scg/swspan.htm#wp1401252
HTH,
-amit singh
07-07-2006 10:18 AM
Hi Amit,
Do all the swithces have to be in the same VTP domain?
07-09-2006 05:42 AM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: