06-09-2006 12:40 AM - edited 03-03-2019 03:34 AM
what is difference between RSTP and STP?
in which condition i shold go for RSTP and STP?
dporter
Solved! Go to Solution.
06-09-2006 11:54 PM
here you can have good information on RSTP and STP differenece and concepts
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/12_1e/swconfig/spantree.htm
and here one scenario is given
http://www.dell.com/downloads/global/products/pwcnt/en/app_note_13.pdf
hope this will helps you
rate the post if it helps
regards
Devang
06-09-2006 01:05 AM
Hello Dave,
basically, RSTP is an enhancement to STP, the main difference being the improved convergence when recalculating the spanning tree. RSTP convergers in roughly 1 second, whereas STP can take up to 50 seconds. Watch out though: not all switches support RSTP, and for some, you need the enhanced image to support it (e.g. the 2950 switches).
Have a look at this document as well:
Understanding Rapid Spanning Tree Protocol (802.1w)
http://www.cisco.com/warp/public/473/146.html
HTH,
GNT
06-09-2006 05:54 AM
The nice thing between RSTP and STP is they are compatible... so if you have a switch A running RSTP connected to Switch B running STP, Swtich A will notice that Switch B is not a RSTP switch and it will go through the 50 seconds convergence time with switch B.
06-09-2006 11:54 PM
here you can have good information on RSTP and STP differenece and concepts
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/12_1e/swconfig/spantree.htm
and here one scenario is given
http://www.dell.com/downloads/global/products/pwcnt/en/app_note_13.pdf
hope this will helps you
rate the post if it helps
regards
Devang
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: