Good Morning,
We have a setup in place where one of our edge routers connect to a switch through a Motorola Canopy wireless bridge. What I am wondering is; Can I put a c1310 bridge setup at the switch end between the Canopy transport without having to add a switch between the 1310 bridge and Motorola Canopy?
Here are the connection configs:
****on rtr****
interface GigabitEthernetg/g
description 10.e.e.1 LAN-UPLINK to rm-so-3550PWR24-1 int Fa0/24
ip address 10.e.e.1 255.255.255.248
ip access-group outbound in
ip helper-address 10.d.d.d
ip pim sparse-dense-mode
duplex full
speed 100
ip route 0.0.0.0 0.0.0.0 10.w.w.1 ##route to wan-agg rtr
ip route 10.e.0.0 255.255.0.0 10.e.0.4 ##route to egde sw
****on edge sw****
interface FastEthernet0/24
description WAN link - UPLINK to rm-r1-rm.wanagg in Faf/f
no switchport
ip address 10.e.e.4 255.255.255.248
ip pim sparse-dense-mode
duplex full
speed 100
mls qos trust dscp
ip route 0.0.0.0 0.0.0.0 10.e.e.1 ##route to agg rtr
diagram of setup and temporary setup:
Thank you in advance.
