Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SAA

I need to monitor a router with an Agilent aplication, and in the documentation of the aplication says that my router must me "Cisco SAA-enabled", at this moment I have enabled the "type echo protocol ipIcmpEcho" this instruction is working in the router but I still have the doubt of how to know if my router has the SAA enabled because when I try to send a SAA ping from the aplication it didn't work

1 REPLY

Re: SAA

As long as rtr responder is there in the configuration, SAA should be working. Use additional show commands to verify whether rtr is working or not.

This link might help

http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_configuration_guide_chapter09186a00800ca63e.html

228
Views
0
Helpful
1
Replies
CreatePlease to create content