04-07-2003 04:27 AM - edited 03-02-2019 06:27 AM
Hi,
Iam looking for sample configuration for Cisco Router3640 with NM4T & Cisco Router 2610 with WIC 2T Connected Back To Back.
Mudassir.
04-07-2003 06:32 AM
Hi mmali
after implementing hardware reqirments on both sides of the link
you got to define ip addresses and encapsulation of the link
but the important thing that you should configure is the "clockrate"
since the routers are usually DTE devices and they will connect to the outside world via a DCE device the DCE will provide the clockrate
but when you emulate the wan link one of the routers will become
DCE and you should configure the clock rate on the DCE router
wiht the command "clockrate XXXXX"
on the interface configuration mode
and you can find out whether this router is DCE or the other one
via the command "show controllers serial x/x "
on both sides of the link .
Best Regards
04-07-2003 06:38 AM
Hi,
For Cisco Router 3640 with NM 4T iam using V.35 DCE cable.
and for Cisco Router 2610 with WIC 2T iam using V.35 DTE cable.
and i configured clock rate on Cisco Router 3640.
.
Regards,
Mudassir
04-07-2003 06:44 PM
Visit following link which discuss exactly that with sample config and troubleshooting
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: