Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Sample configuration for 3640 NM4T & 2610 WIC 2T Back To Back

Hi,

Iam looking for sample configuration for Cisco Router3640 with NM4T & Cisco Router 2610 with WIC 2T Connected Back To Back.

Mudassir.

3 REPLIES
New Member

Re: Sample configuration for 3640 NM4T & 2610 WIC 2T Back To Bac

Hi mmali

after implementing hardware reqirments on both sides of the link

you got to define ip addresses and encapsulation of the link

but the important thing that you should configure is the "clockrate"

since the routers are usually DTE devices and they will connect to the outside world via a DCE device the DCE will provide the clockrate

but when you emulate the wan link one of the routers will become

DCE and you should configure the clock rate on the DCE router

wiht the command "clockrate XXXXX"

on the interface configuration mode

and you can find out whether this router is DCE or the other one

via the command "show controllers serial x/x "

on both sides of the link .

Best Regards

New Member

Re: Sample configuration for 3640 NM4T & 2610 WIC 2T Back To Bac

Hi,

For Cisco Router 3640 with NM 4T iam using V.35 DCE cable.

and for Cisco Router 2610 with WIC 2T iam using V.35 DTE cable.

and i configured clock rate on Cisco Router 3640.

.

Regards,

Mudassir

Cisco Employee

Re: Sample configuration for 3640 NM4T & 2610 WIC 2T Back To Bac

Visit following link which discuss exactly that with sample config and troubleshooting

http://www.cisco.com/warp/public/116/ppp_back.html

675
Views
0
Helpful
3
Replies
CreatePlease to create content